Input Voltage Check - Honda GL1800 Service Manual

INPUT VOLTAGE CHECK

Temporarily install the battery.
Turn the ignition to "ON" and measure the voltage
between the Brown wire terminal (+) of the wire har-
ness side 3P connector and ground (–).
There should be battery voltage.
– If there is no voltage, check for an open circuit in
the Brown wire between the reverse shift actua-
tor and fuse box (No. 10 fuse).
OPERATION CHECK
Make sure the reverse shift actuator is in the neutral
position.
Check for continuity between the Brown and Black/
white wire terminals of the actuator side 3P
connector.
There should be continuity.
Turn the actuator to the reverse position by con-
necting a fully charged 12-V battery to the actuator
side 2P connector terminals.
CONNECTION: Positive (+) – Blue
Negative (–) – Blue/red
Check for continuity between the Brown and White/
blue wire terminals of the actuator side 3P
connector.
There should be continuity.
REMOVAL/INSTALLATION
Remove the following:
– right engine side cover (page 2-5)
– ABS modulators (page 16-31)
Loosen the lock nuts and adjusting nuts on the
reverse shift actuator cables fully.
STARTER/REVERSE SYSTEM
WIRE HARNESS SIDE REVERSE
ACTUATOR 3P CONNECTOR
(viewed from the terminal side)
rown
EVE SE SHIFT ACTUATO
PULLEY (NEUT AL POSITION)
EVE SE SHIFT ACTUATO
PULLEY ( EVE SE POSITION)
DJUSTING NUTS
LOCK NUTS
19-37