GEARSHIFT LINKAGE/TRANSMISSION
Remove the following:
– sixteen cover bolts in a crisscross pattern in sev-
eral steps
– two dowel pins
– oil orifice and O-ring
– clutch regulator valve and O-ring
– gasket
Turn the inner race of each bearing with your finger.
The bearings should turn smoothly and quietly.
Also check that the bearing outer race fits tightly in
the cover.
CLUTCH REGULATOR VALVE CHECK
Remove the following:
– snap ring
– spring seat
– valve spring
– piston
Check the piston for wear, unsmooth movement or
other damage.
Check the spring for fatigue or damage.
Install the piston, spring and spring seat, and secure
them with the snap ring.
10-12
EA C ANKCASE COVE
ORIFICE AN O-RING
EGULATO VALVE
GASKET
OWEL
PINS