Honda GL1800 Service Manual page 235

Hide thumbs Also See for GL1800:
Table of Contents

Advertisement

ENGINE REMOVAL/INSTALLATION
Remove the bolt and rear brake reservoir stay.
Slide the rubber cap off the reverse switch terminal,
and remove the nut and reverse switch wire.
Slide the rubber cap off the starter motor terminal,
and remove the terminal nut and starter/reverse
motor cable.
Disconnect the side stand switch 3P green connec-
tor and remove the wire band.
Slide the rubber cap off the alternator terminal, and
remove the terminal nut and alternator cable.
Disconnect the alternator 4P connector.
Disconnect the evaporative emission (EVAP) purge
control solenoid valve connector.
Remove the EVAP purge control solenoid valve
from the stay.
Remove the spark plug wires from the ignition coils.
Remove the wire clamp from the stay and remove it
from the No. 2 and No. 5 spark plug wires.
7-6
REVER E WITCH TERMINAL
TARTER/REVER E MOTOR TERMINAL
3P GREEN
CONNECTOR
LTERN TOR TERMIN L
SOLENO D VALVE
TAY BOLT
4P CONNECTOR
GN T ON CO LS
CONNECTOR

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gl1800a

Table of Contents