CYLINDER/PISTON/CRANKSHAFT
RIGHT CYLINDER SIDE
Cover the transmission gears and crankcase mating
surfaces with shop towels to prevent damaging the
BEARING CA
pistons during installation.
Apply molybdenum oil solution to the crankpin
bearing sliding surfaces on the connecting rods and
bearing caps.
ISTON/CONNECTING ROD
Install the right piston/connecting rod assemblies
and bearing caps (No. 1, 3 and 5) onto the corre-
Front
sponding crankpins with the "R" mark toward the
1
intake side by aligning the I.D. code. Be sure each
5
part is installed in its correct position.
3
"R" MARK
I.D. CODE
Apply engine oil to the bearing cap nut threads and
seating surfaces and install the them.
Tighten the nuts in several steps alternately.
TORQUE: 31 N·m (3.2 kgf·m, 23 lbf·ft)
Assemble the crankcase halves.
UTS
11-21