BRAKE SYSTEM (Standard)
Remove the two mounting bolts (lower pivot and
upper joint bolts) and brake caliper.
Remove the pivot collars from the fork and caliper
bracket.
Check the pivot bearings and dust seals in the fork
leg for wear or damage.
For pivot bearing replacement, see page 13-23.
RIGHT CALIPER
Remove the brake pads (page 15-13).
Disconnect the brake hoses from the brake caliper
by removing the oil bolts and sealing washers.
Remove the following:
ABS model only:
– bolt and wire clamp from fork leg
Being careful not to
– two bolts, clamp and wheel speed sensor from
damage the speed
caliper bracket
sensor and sensor
wire.
Remove the two mounting bolts and brake caliper.
DISASSEMBLY
Remove the following:
– caliper bracket
– boots
– pad spring
15-28
IVOT BOLT
IL B LTS
eft caliper shown:
BRACKET
BOOT
PAD SPRING
JOINT
BOLT
CALI ER
BOOT