Left Cylinder Side - Honda GL1800 Service Manual

Hide thumbs Also See for GL1800:

Table of Contents

CYLINDER/PISTON/CRANKSHAFT

PISTON/CONNECTING ROD

INSTALLATION

LEFT CYLINDER SIDE

Slip short sections of rubber hose over the connect-

ing rod bolts to prevent damaging the crankpin.

Apply engine oil to the left cylinder wall, piston and

piston rings.

Install the left piston/connecting rod assemblies

Be careful not to

(No. 2, 4 and 6) into the correct cylinders from the

damage the piston

cylinder top of the left crankcase with the "L" mark

rings and the cylin-

toward the intake side, using a commercially avail-

der wall by the con-

able piston ring compressor tool.

necting rod.

Apply molybdenum oil solution to the crankpin

bearing sliding surfaces on the connecting rods.

Set the connecting rods onto the crankpins.

Apply molybdenum oil solution to the crankpin

bearing sliding surfaces on the connecting rods.

Install the bearing caps by aligning the I.D. code on

the connecting rod and bearing cap. Be sure each

part is installed in its correct position, as noted dur-

ing removal.

Apply engine oil to the bearing cap nut threads and

seating surfaces and install the them.

Tighten the nuts in several steps alternately.

TORQUE: 31 N·m (3.2 kgf·m, 23 lbf·ft)

ONNE TING ROD