Honda GL1800 Service Manual page 605

Hide thumbs Also See for GL1800:
Table of Contents

Advertisement

STARTER/REVERSE SYSTEM
Install the washers and snap ring onto the starter
shaft.
Install the following:
– insulator
– insulated brush
– cable terminal
– new O-ring
– insulator washers
– washer
– nut
Install the brush holder, aligning the tab with the
groove in the case, and wire grooves with the insu-
lated brush wires.
Push and hold the brushes inside the brush holder,
The coil may be
and install the armature through the motor case and
damaged if the
brush holder.
magnet pulls the
When installing the armature into the motor case,
armature against
hold the armature tightly to prevent the magnet of
the case.
the case from pulling the armature against it.
Install the washer and a new seal ring.
Install the rear cover, aligning the slot with the
brush holder tab.
19-22
O-R NG
NSULATOR
WASHERS
NUT
WASHER
RUSH
WIRES
BRUSH
TERM NAL
NSULATOR
RUSH HOLDER
TA AND
GROOVE

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gl1800a

Table of Contents