FRAME/BODY PANELS/EXHAUST SYSTEM
TRUNK LOCK COVER
Open the trunk lid.
Remove the two self-tapping screws, three screws
and trunk lock cover.
Install the trunk lock cover in the reverse order of
removal.
TRUNK
Remove the following:
– seat (page 2-5)
– rear fender A (page 2-13)
– trunk lower cover (page 2-13)
– trunk lock cover
– passenger headset connector from the holder
Disconnect the saddlebag opener cables and sub-
wire
connector.
Disconnect the antenna connector and 12P connec-
tor of the trunk control unit sub-wire harness and
14P connector of the trunk sub-wire harness.
Remove the wire bands.
Remove the four mounting bolts, three washers and
trunk assembly from the stay.
Installation is in the reverse order of removal.
Route the wires
and cables properly
(page 1-23).
14P CONNECTOR
2-14
harness
connectors
and
ANTENNA
CONNECTOR
14P CONNECTOR
SELF-
APPING
SCREWS
license
light
TRUNK ASSEMBLY
WIRE BAND
HEADSET
CONNECTOR
RUNK OPENER COVER
SCREWS
BOLTS
WASHERS
SADDLEBAG
OPENER CABLES
WIRE BAND
SADDLEBAG
CONNECTORS