Radiator/Cooling Fan Removal; Right Radiator - Honda GL1800 Service Manual

COOLING SYSTEM
Fill the system with the recommended coolant
through the filler opening up to the filler neck.
Install the radiator cap.
Bleed air from the system as follows:
1. Shift the transmission into neutral.
Start the engine and let it idle for 2 – 3 minutes.
2. Snap the throttle three to four times to bleed air
from the system.
3. Stop the engine and add coolant up to the filler
neck.
4. Install the radiator cap.
Remove the reserve tank cap/dipstick.
Fill the reserve tank to the upper level hole of the
dipstick with the motorcycle on its center stand on a
flat, level surface.
Install the following:
– left engine side cover (page 2-5)
– front lower fairing (page 2-6)
– right fairing pocket (page 2-12)
RADIATOR/COOLING FAN
REMOVAL
Drain the coolant from the system (page 6-6).
Remove the front fairing (page 2-10).
Remove the top shelter (page 2-11).

RIGHT RADIATOR

Disconnect the right radiator fan motor 2P (white)
Be careful not to
connector.
damage the radiator
fins while servicing
the radiator.
6-8
ILLER NECK
P WHITE CONNECTOR