Final Drive Service Information; Final Drive Torque Values - Honda GL1800 Service Manual

SERVICE INFORMATION
GENERAL
• Perform the gear contact pattern and backlash inspection whenever you replace the bearings, gears or gear case. The
extension lines from the gear engagement surfaces should intersect at one point.
• Protect the gear case with a shop towel or soft jaws while holding it in a vise. Do not clamp the gear case too tight or it
could get damaged.
• Replace the ring and pinion gears as a set.
SPECIFICATIONS
ITEM
Recommended final drive oil
Final drive oil After draining
capacity
After disassembly
Final drive gear backlash
Backlash difference between measurements
Final drive gear assembly preload
TORQUE VALUES
Pinion retainer
Pinion retainer lock tab bolt
Pinion joint nut
Final side flange screw
Gear case cover 10 mm bolt
Gear case cover 8 mm bolt
Final gear case assembly mounting
nut
Rear brake disc screw
Rear brake caliper mounting bolt
Brake hose clamp bolt
Rear brake hose guide bolt (After '03)
Wheel speed sensor bolt (ABS
model)
Hypoid gear oil, SAE #80
3
120 cm (4.1 US oz, 4.2 Imp oz)
3
150 cm (5.1 US oz, 5.3 Imp oz)
0.05 – 0.15 (0.002 – 0.006)
0.2 – 1 N·m (2 – 10 kgf·cm, 1.7 – 8.7 lbf·in)
147 N·m (15.0 kgf·m, 108 lbf·ft)
10 N·m (1.0 kgf·m, 7 lbf·ft)
108 N·m (11.0 kgf·m, 80 lbf·ft)
9 N·m (0.9 kgf·m, 6.5 lbf·ft)
62 N·m (6.3 kgf·m, 46 lbf·ft)
25 N·m (2.6 kgf·m, 19 lbf·ft)
88 N·m (9.0 kgf·m, 65 lbf·ft)
9 N·m (0.9 kgf·m, 6.5 lbf·ft)
45 N·m (4.6 kgf·m, 33 lbf·ft)
12 N·m (1.2 kgf·m, 9 lbf·ft)
12 N·m (1.2 kgf·m, 9 lbf·ft)
12 N·m (1.2 kgf·m, 9 lbf·ft)
STANDARD
–
Apply engine oil to the threads and
seating surface.
Apply locking agent to the threads.
ALOC screw: replace with a new
one.
Apply locking agent to the threads.
Apply locking agent to the threads.
ALOC screw: replace with a new
one.
ALOC bolt: replace with a new one.
FINAL DRIVE
Unit: mm (in)
SERVICE LIMIT
–
–
–
0.30 (0.012)
0.10 (0.004)
–
12-3