Honda GL1800 Service Manual page 246

ENGINE REMOVAL/INSTALLATION
Connect the clutch hose to the clutch slave cylinder
EALING
with the oil bolt and new sealing washers, and
WA HER
tighten the oil bolt.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Fill and bleed the clutch hydraulic system
(page 9-7).
OIL BOLT
Install the coolant drain joint and EVAP canister
Route the canister
bracket onto the engine with the two mounting
hoses properly
bolts.
(page 1-23).
Connect the No. 4 and No. 1 hoses to the EVAP
canister.
Install the wire band.
Connect the connectors to both horns.
Connect both knock sensor connectors.
Install the wire clamp onto the No. 2 and No. 5 spark
GN T ON CO LS
plug wires and install it onto the stay.
Connect the spark plug wires to the ignition coils.
Install the EVAP purge control solenoid valve onto
the stay and connect the solenoid valve connector.
SOLENO D VALVE CONNECTOR
7-17