Honda GL1800 Service Manual page 631

STARTER/REVERSE SYSTEM
Coat the reverse shifter shaft with molybdenum oil
solution.
Install the reverse shifter assembly onto the shaft.
Coat the roller pin with grease.
Install the roller pin into the hole in the shaft
through the guide holes in the shifter.
Install the reverse shifter shaft assembly into the
shift drum lock arm while aligning the flat on the
shaft end with the flat in the lock arm hole.
Further insert the shifter shaft assembly while align-
ing the shifter groove with the stopper shaft
Install the reverse idle gear with the "OUT" mark
facing out.
Install the washer.
Coat the starter reduction gear shaft with molybde-
num oil solution and install it into the gear holder.
Install the starter reduction gear onto the shaft.
Install the rear crankcase cover (page 10-24).
19-48
HIFTER GROOVE
REDUCTION GEAR REVERSE IDLE GEAR
GEAR SHAFT WASHER
TOPPER HAFT
"OUT"
MARK