Honda GL1800 Service Manual page 327

GEARSHIFT LINKAGE/TRANSMISSION
Install the following onto the output shaft:
– reverse driven gear (with dished side facing
spring)
– damper spring
– damper lifter
– thrust washer
– final driven gear (by aligning its grooves with
lifter lugs)
– gear bushing (apply engine oil)
Press a new bearing onto the output shaft using the
Install the bearing
special tool.
with the sealed
side facing up.
TOOL:
Driver, 22 mm I.D.
Install the cotters into the cotter groove.
Install the retainer by aligning its tab with the
groove in the shaft and turn it to set the tab in the
opposite position of the groove.
Secure the retainer with the snap ring.
10-18
REVER E DRIVEN GEAR
AND LU S
07746-0020100
COTTE S
PRING
ROOVES
FINAL DRIVEN EAR
RIVER
BEARING
G OOVE
Align
TAB
SNAP ING
ETAINE
LIFTER
WA HER
BUSHIN