Honda GL1800 Service Manual page 241

Hide thumbs Also See for GL1800:

Table of Contents

ENGINE REMOVAL/INSTALLATION

Use a floor jack or other adjustable support to care-

fully maneuver the engine into place.

Apply 1 g (0.04 oz) of molybdenum disulfide grease

to the output shaft splines.

Install the engine in the frame while engaging the

Be careful not to

universal joint splines with the output shaft splines.

damage the wire

Install the joint boot over the output gear case

harnesses, hoses,

and cables during

engine installation.

Temporarily install the sub-frames, front and rear

engine hanger bolts and nuts, then tighten the

engine mounting fasteners to the specified torque

in the correct sequence.

1. Tighten the right sub-frame mounting bolts.

2. Install and tighten the right rear engine hanger

TORQUE: 64 N·m (6.5 kgf·m, 47 lbf·ft)

UNIVERSAL OINT

CENTER: 10 mm BOLT, NUT

RONT: 12 mm BOLT, NUT

IGHT SUB-F AME BOLTS

Troubleshooting