Transmission Disassembly; Right Crankcase; Shift Fork And Shift Drum - Honda GL1800 Service Manual

GEARSHIFT LINKAGE/TRANSMISSION
Install a new oil seal until it is fully seated.
TOOLS:
Driver
Attachment, 42 x 47 mm
Coat a new O-ring with engine oil and install it into
the bearing holder groove.
Pack grease into the oil seal lip cavity and install the
bearing holder, being careful not to damage the seal
lips.
Install the three bolts and tighten them.
TORQUE: 28 N·m (2.9 kgf·m, 21 lbf·ft)
Install the following:
– clutch (page 9-20)
– water pump (page 6-18)
– alternator (page 17-18)
– starter/reverse motor (page 19-17)
– reverse shift arm/cables (page 19-49)
– engine (section 7)

TRANSMISSION DISASSEMBLY

Separate the crankcase (page 11-6).

RIGHT CRANKCASE

SHIFT FORK AND SHIFT DRUM:

Remove the following:
– two bolts
– shift drum setting plate
10-26
07749-0010000
07746-0010300
-RING
EARING HOLDER
ETTING PLATE
BOLT