16
ENGINE
16.5.32 Installing oil screens
16.5.33 Installing the starter motor
–
Position the alternator cover.
–
Mount and tighten screws
Guideline
Screw, alternator cover
–
Mount and tighten screws
Guideline
Screw, alternator cover
305519-10
–
Mount and tighten screw
Guideline
Screw, alternator cover
(chain shaft through-hole)
–
Push the oil screen with O-rings on to a pin wrench. Push the pin wrench through
the opening into the drill hole of the opposite engine case wall and push the oil
screen as far as possible into the engine case.
305510-10
–
Mount the oil drain plug
Guideline
Oil drain plug with magnet
–
Mount and tighten screw plug
Guideline
Plug, oil screen
305508-10
–
Position the oil screen
–
Mount and tighten screw plug
Guideline
Plug, oil screen
305511-10
–
Grease the O-ring and mount the starter motor.
Long-life grease (
–
Mount and tighten oil throttle
Guideline
Screw, starter motor with
oil throttle
305513-10
.
M6x25
.
M6x30
.
M6x25
10 Nm
(7.4 lbf ft)
with the magnet and a new seal ring and tighten it.
M12x1.5
with the O-ring.
M20x1.5
with O-rings.
with the O-ring.
M20x1.5
p. 226)
.
M6
10 Nm
(7.4 lbf ft)
172
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
Loctite
®
243™
20 Nm
(14.8 lbf ft)
15 Nm
(11.1 lbf ft)
15 Nm
(11.1 lbf ft)
Loctite
®
243™