8
SHOCK ABSORBER, SWINGARM
–
Grease O-ring
Lubricant (T158) (
–
Mount the piston rod carefully.
201278-11
–
Install the seal ring bearer
–
Mount lock ring
Info
Do not scratch the inner surface.
–
Pull out the piston rod so that the seal ring retainer rests against the lock ring.
201276-10
–
Mount locking cap
–
Bleed and fill the damper. (
–
Fill the damper with nitrogen. (
201275-10
Alternative 1
–
Turn adjusting screw
click.
–
Turn back counterclockwise by the number of clicks corresponding to the shock
absorber type.
Guideline
Compression damping, low-speed
Comfort
Standard
201287-10
Sport
Full load capacity
–
Turn adjusting screw
–
Turn back counterclockwise the number of turns corresponding to the shock
absorber type.
Guideline
Compression damping, high-speed
Comfort
Standard
Sport
Full payload
–
Turn adjusting screw
–
Turn back counterclockwise by the number of clicks corresponding to the shock
absorber type.
of the seal ring retainer.
p. 226)
and push it under the ring groove.
.
of the damper cartridge.
p. 48)
p. 50)
clockwise with a screwdriver up to the last perceptible
all the way clockwise using a socket wrench.
clockwise up to the last perceptible click.
25 clicks
20 clicks
15 clicks
15 clicks
2 turns
1.5 turns
1 turn
1 turn
47