16
ENGINE
–
Mount the sixth-gear sliding gear
–
Position special tool
Mounting tool for lock ring (75029005000) (
–
Position lock ring
on special tool
The lock ring engages in the groove of the transmission shaft.
–
Mount stop disk
.
–
Mount needle bearing
–
Mount needle bearing
–
Mount stop disk
.
–
Position special tool
Mounting tool for lock ring (75029005000) (
–
Position lock ring
on special tool
The lock ring engages in the groove of the transmission shaft.
–
Mount the fifth-gear sliding gear
–
Mount needle bearing
–
Finally, check all gear wheels for smooth operation.
16.4.39 Checking the starter drive
–
Check the teeth and seating of the starter idler gear
»
If there is damage or wear:
–
Change the starter idler gear and/or needle bushing.
–
Check the teeth and seating of torque limiter
»
If there is damage or wear:
–
Change the torque limiter and/or needle bearing.
–
Check freewheel gear
»
If there is damage or wear:
with the shift groove facing upward.
on the transmission shaft.
p. 233)
and push down with sleeve
and the fourth-gear idler gear
and the third-gear idler gear
on the transmission shaft.
p. 233)
and push down with sleeve
with the shift groove facing downward and stop disk
, first-gear idler gear
with the recess facing downward and stop disk
for damage and wear.
and bearing when removed for damage and wear.
.
with the collar facing upward.
with the collar facing downward.
.
for damage and wear.
.
.
152
305600-10