16
ENGINE
16.5.13 Installing the ignition pulse generator
16.5.14 Installing timing chain and timing chain sprocket
16.5.15 Installing the timing chain rails
–
Position the ignition pulse generator.
–
Mount screws
Guideline
Screw, crankshaft position
sensor
–
Position the cable and position cable sleeve
305572-10
–
Heat the timing chain sprocket and push it immediately on to the crankshaft.
Guideline
100 °C (212 °F)
–
Mount lock ring
305570-11
–
Thread the timing chain
Info
If the timing chain is not new, pay attention to the direction of travel.
305569-11
–
Position the timing chain securing guide
The ignition pulse generator cable is routed in the cable duct of the timing
chain securing guide.
305567-10
–
Position the timing chain tensioning rail
–
Insert the support bushing into the timing chain securing guide.
305566-11
but do not tighten yet.
M6x16
.
in and lay it over the timing chain sprocket.
Loctite
®
10 Nm
(7.4 lbf ft)
in the engine case.
.
from above.
162
243™