Table of Contents
Advertisement
6
FORK, TRIPLE CLAMP
6.8
Installing the fork legs
–
Loosen the screws
G00829-10
–
Slide the fork legs into the triple clamps on both sides.
Info
The bleeder screws must face forwards.
The topmost milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
The upper fork projection must be the same on both sides.
–
Tighten screws
Guideline
G00829-11
Screw, top triple clamp
Screw, bottom triple clamp
–
Position the fork protection. Mount and tighten screws
Guideline
Remaining screws, chassis
G00832-11
–
Position the brake line, wiring harness and clamp.
–
Mount and tighten screws
G00828-11
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the
brake discs.
–
–
Clean screw
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
G00830-11
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
of the triple clamp. Remove the fork legs from the bottom.
on both sides.
.
Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.
and the wheel spindle.
.
M8
17 Nm
(12.5 lbf ft)
M8
12 Nm (8.9 lbf ft)
.
M6
10 Nm (7.4 lbf ft)
M24x1.5
45 Nm
(33.2 lbf ft)
17
Advertisement
Table of Contents
