Table of Contents
Advertisement
6
FORK, TRIPLE CLAMP
6.12
Checking the steering head bearing play
Warning
Danger of accidents Unstable vehicle handling from incorrect steering head bearing play.
–
Adjust the steering head bearing play without delay.
Info
If the bike is ridden with play in the steering head bearing, the bearing and the bearing seats in the frame can become dam-
aged over time.
6.13
Adjusting the steering head bearing play
Alternative 2
–
Return the adjusting screws to the position determined when the unit was dis-
assembled.
Preparatory work
–
Raise the motorcycle with the work stand. (
–
Push down the rear of vehicle, tighten it down in this position, and secure the
motorcycle against falling over.
The front wheel is no longer in contact with the ground and the fork legs are no
longer under tension.
Main work
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
»
If there is noticeable play present:
–
Adjust the play of the steering head bearing. (
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. No
600636-10
resting locations should be noticeable.
»
If click positions are noticeable:
–
Adjust the play of the steering head bearing. (
–
Check the steering head bearing and change if necessary.
Finishing work
–
Release the rear of the vehicle.
–
Remove the motorcycle from the work stand. (
Preparatory work
–
Raise the motorcycle with the work stand. (
–
Push down the rear of vehicle, tighten it down in this position, and secure the
motorcycle against falling over.
The front wheel is no longer in contact with the ground and the fork legs are no
longer under tension.
Warning
Danger of accidents Modifications to the suspension settings can seri-
ously alter the vehicle's ride behavior.
–
Extreme modifications to the adjustment of the suspension compo-
nents can cause a serious deterioration in the handling characteris-
tics and overload some components.
–
Only make adjustments within the recommended range.
–
After making adjustments, ride slowly at first to get the feel of the
new ride behavior.
p. 11)
p. 26)
p. 26)
p. 12)
p. 11)
26
Advertisement
Table of Contents
