Table of Contents
Advertisement
16
ENGINE
Main work
–
Position the crankshaft with special tool
Under part, pressing-out tool (75029047051) (
–
Position special tool
Upper part, pressing-out tool (75029047050) (
–
Press the crank pin out of the upper crankweb with the push-out drift of the special
tool.
302151-10
Pressing device for crankshaft, complete (75029047000) (
Info
Hold the lower crankweb.
–
Take off the connecting rod and bearing.
–
Press the crank pin out of the crankweb.
300138-10
–
Press in the new crank pin
Info
The crank pin must be pressed in so that oil channel
channel
If the oil channels are not correctly aligned, the conrod bearing will not be
supplied with oil.
–
Blow compressed air through the oil channel to check that it is clear.
305653-10
–
Mount bearing
Info
Thoroughly lubricate the bearing.
305654-10
–
Position special tool
Pressing device for crankshaft, complete (75029047000) (
–
Place the crankweb in with the connecting rod and the bearing. Position the second
crankweb.
300142-10
between the crankwebs.
as far as possible.
.
and connecting rod
on the press.
in the press.
p. 235)
p. 234)
p. 234)
is aligned with oil
.
p. 234)
129
Advertisement
Table of Contents
