14
BRAKE SYSTEM
14.3
Adjusting the basic position of the hand brake lever
14.4
Checking brake fluid level of front brake
Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule.
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover with membrane
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
G00807-10
–
Push the spring hanger forward from spring
–
Remove springs
–
Clean the brake caliper.
–
Insert new brake linings
Info
The spring hanger of springs
400421-10
–
Add brake fluid to level
Guideline
Level
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
G00806-11
–
Adjust the basic setting of the hand brake lever to your hand size by turning adjust-
ing wheel
Info
Pull the hand brake lever forward and turn the adjusting wheel.
Do not make any adjustments while riding!
B01955-10
.
.
. Remove brake linings
. Position springs
.
p. 224)
.
and pull out pin
.
and mount pins
must be positioned upward.
5 mm (0.2 in)
90
.
.