Installing The Left Engine Case - KTM 2014 690 SMC R EU Repair Manual

16 ENGINE
16.5.3

Installing the left engine case

–
Push the crankshaft into the bearing seat and take off the special tool.
–
Grease the shaft seal rings of the balancer shaft.
–
Push the balancer shaft
Align marks
–
Mount stop disk
305644-10
–
Mount the dowels.
–
Mount O-ring
–
Degrease the sealing area. Apply the sealing compound to the left section of the
engine case.
Loctite ® 5910
305635-10
–
Put on the left section of the engine case. If necessary, tap lightly with a rubber
mallet and turn the transmission shafts.
Info
Do not tighten the engine case sections using the screws.
–
Mount screw
Guideline
Screw, engine case
305636-10
–
Mount screw
Guideline
Screw, engine case
–
Mount screws
Guideline
Screw, engine case
–
Mount screw
Guideline
Screw, engine case
Info
Mount the screw with a new copper washer.
–
Tighten all screws in a crisscross pattern.
Guideline
Screw, engine case
 into the bearing seat and take off the special tool.
 
and .

.

.
 but do not tighten it yet.
 but do not tighten it yet.

but do not tighten yet.

with washer but do not tighten it yet.
M6x80 10 Nm (7.4 lbf ft)
M6x70 10 Nm (7.4 lbf ft)
M6x30 10 Nm (7.4 lbf ft)
M6x25 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
156