Adding Rear Brake Fluid - KTM 2014 690 SMC R EU Repair Manual

14 BRAKE SYSTEM
14.12

Adding rear brake fluid

Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding.
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
–
Stand the vehicle upright.
–
Check the brake fluid level in the brake fluid reservoir.
»
If the fluid level reaches the MIN marking
–
Add rear brake fluid. (
101992-10
Preparatory work
–
Check the rear brake linings. (
Main work
–
Stand the vehicle upright.
–
Remove screw cap
–
Add brake fluid to the MAX mark.
Brake fluid DOT 4 / DOT 5.1 (
–
Mount the screw cap with the washer and membrane.
Info
101993-10
Clean up overflowed or spilt brake fluid immediately with water.

p. 96)
p. 93)

with the washer and membrane
p. 224)
:

.
96