Removing The Valves - KTM 2014 690 SMC R EU Repair Manual

16 ENGINE

16.4.22 Removing the valves

–
Remove the small camshaft bearing using special tool
Insert for bearing puller (15112018100) (
Bearing puller (15112017000) (
305670-10
–
Press in the small camshaft bearing as far as possible using special tool
Push-in drift (75029044020) (
305671-10
–
Press in the large camshaft bearing as far as possible using special tool
Push-in drift (75029044010) (
305672-10
Finishing work
–
Install the rocker arm. (
–
Pretension the valve springs using the special tool.
Valve spring compressor (59029019000) (
Valve spring mounting device (78029060000) (
–
Remove the valve keys and release the tension on the valve springs.
–
Remove the spring retainer and spring.
–
Pull the valve down and out of the valve guide, and remove the valve stem seal and
valve spring seat.
300116-10
–
Mark the valves according to their normal built-in position.
Info
Place the valves into a box according to the installation position and label
the box.
300117-10
p. 228)
p. 228)
p. 234)
p. 234)
p. 142)
p. 230)
p. 237)
139

.

.

.