16
ENGINE
–
Position the hoses of the engine breather, the SAS, and the oil return line. Mount
the spring band clamp
Pliers for spring band clamp (60029057100) (
G00843-11
–
Attach the spark plug connectors.
–
Plug in the connector of the engine coolant temperature sensor
G00842-11
–
Connect plug-in connectors
sor, and alternator.
G00841-11
–
Position the throttle valve body.
–
Position and tighten hose clip
G00840-11
–
Position the electrical connection
screw. Mount the protection cap.
Guideline
Screw, cable on starter motor
–
Position the ground wire on the starter motor. Mount and tighten screw
Guideline
Screw, starter motor
G00839-11
–
Insert the clutch push rod.
–
Position the clutch slave cylinder.
–
Mount and tighten screws
Guideline
Screw, clutch slave cylin-
der
Screw, clutch slave cylin-
der
G00838-11
–
Secure the cable with cable binders
using the special tool.
of the gear position sensor, crankshaft position sen-
.
on the starter motor. Mount and tighten
M5
M6x20
10 Nm
(7.4 lbf ft)
.
M6x20
10 Nm
(7.4 lbf ft)
M6x35
10 Nm
(7.4 lbf ft)
.
p. 231)
.
3 Nm (2.2 lbf ft)
.
Loctite
®
243™
Loctite
®
243™
–
109