Table of Contents
Advertisement
14
BRAKE SYSTEM
14.7
Checking the rear brake linings
Warning
Danger of accidents Reduced braking efficiency caused by worn brake linings.
–
Change worn brake linings immediately.
Note
Danger of accidents Reduced braking efficiency caused by damaged brake discs.
–
If the brake linings are not changed in time, the steel brake lining carriers grind on the brake disc. The braking effect is greatly
reduced and the brake discs are destroyed. Check the brake linings regularly.
14.8
Changing the rear brake linings
Warning
Danger of accident Brake system failure.
–
Maintenance work and repairs must be carried out professionally.
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule.
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Open the bleeder screw again until brake fluid stops emerging.
Info
This prevents overfilling of the brake fluid reservoir.
–
Tighten the bleeder screw. Remove the hose of the bleeder bottle. Mount the pro-
tection cap.
–
Disconnect the bleeding device. Remove the bleeder cover.
–
Correct the brake fluid level.
Guideline
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
G00806-10
–
Check the hand brake lever for a firm pressure point.
–
Check the brake linings for minimum thickness
Minimum thickness
»
If the minimum thickness is less than specified:
–
Change the rear brake linings. (
–
Check the brake linings for damage and cracking.
»
If there is wear or tearing:
–
Change the rear brake linings. (
101994-10
5 mm (0.2 in)
.
p. 224)
≥ 1 mm (≥ 0.04 in)
p. 93)
p. 93)
.
93
Advertisement
Table of Contents
