12
WHEELS
12.7.2
Installing the rear wheel
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents No braking effect when operating the rear brake.
–
After installing the rear wheel, always operate the foot brake until the pressure point is reached.
–
Pull out wheel spindle
tact with the adjusting screw.
–
Push the rear wheel forwards as far as possible and take the chain off the rear
sprocket.
–
Pull out the wheel spindle.
Warning
Danger of accidents Reduced braking effect caused by damaged brake
discs.
102001-01
–
–
Take the rear wheel out of the swing arm.
Info
Do not operate the foot brake when the rear wheel is removed.
Main work
–
Check the rear hub rubber dampers. (
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Replace the wheel bearing.
–
Remove bushing
shaft seal ring
Long-life grease (
–
Mount the bushing.
–
Clean and grease the threads of the wheel spindle and nut
102002-10
Long-life grease (
–
Mount the rubber damper and rear sprocket carrier in the rear wheel.
–
Position the rear wheel.
The brake linings are correctly positioned.
to the point where the chain adjuster is no longer in con-
Always lay the wheel down in such a way that the brake discs are not
damaged.
. Clean and grease the roll surfaces of the bushing and the
.
p. 226)
p. 226)
p. 80)
.
75