Checking The Electric Starter Drive - KTM Freeride 250 R EU Repair Manual

18 30/ENGINE

18.4.22 Checking the electric starter drive

–
Check the gear mesh and bearing of starter idler gear
» If there is damage or wear:
–
Change the starter idler gear.
–
Check the gear mesh and bearing of Bendix
» If damaged or worn, or if the Bendix does not move easily:
–
Change the Bendix.
–
Check the gear mesh of starter motor
» If there is damage or wear:
–
Change the starter motor.
–
Change O-ring of the starter motor.
4
–
Connect the negative cable of a 12 volt power supply to the housing of the starter motor. Connect the positive cable of the power
supply briefly with the connector of the starter motor.
» If the starter motor does not turn when the circuit is closed:
–
Change the starter motor.
1
for smooth operation, damage and wear.
2
for damage and wear
3
–
Mount the starter idler gear in the alternator cover.
–
Mount cover
–
Mount and tighten screws
Guideline
Screw, alternator cover
–
Mount and tighten a fitting screw
Guideline
Screw, alternator cover
303062-10
303006-10
for damage and wear.
with the gasket.
5
.
6
7
M6
with the washer and nut.
M6
133
8 Nm (5.9 lbf ft)
8 Nm (5.9 lbf ft)