30/ENGINE - WORK ON THE INDIVIDUAL PARTS
Removing the valves
20.20
–
Position the camshafts.
The valves are not activated.
–
Insert the Plastigauge clearance gauge in area
Plastigauge measuring strips (60029012000) (
302706-10
–
Position camshaft bearing bridge
Guideline
Screw, camshaft bearing
bridge
Info
Ensure that the dowel pins are seated properly.
Do not turn the camshaft.
302707-10
–
Remove camshaft bearing bridge
gauge with the specifications on the packaging.
Guideline
Camshaft bearing - sleeve bearing
Radial clearance
Wear limit
Info
302708-10
The width of the Plastigauge clearance gauge is a measure of the bearing
play.
–
Take off the camshafts and clean the parts.
–
Remove screw plugs
–
Screw appropriate screw
–
Hold cam levers
Info
If the cam levers will continue to be used, note down their installation posi-
tion.
–
Take the shims from the valve spring retainers and put them aside corresponding to
their installation position.
302710-10
. Mount and tighten the screws.
1
M7x1
again. Compare the Plastigauge clearance
1
0.020... 0.054 mm (0.00079...
0.00213 in)
0.065 mm (0.00256 in)
with the O-ring.
1
into the cam lever shaft.
2
and remove the cam lever shaft.
3
.
A
p. 274)
14 Nm
Lubricated with
(10.3 lbf ft)
engine oil
142