Storm-Control Broadcast; No Storm-Control Broadcast - NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Mode
Acceptable values are:
100h
100f
10h
10f

storm-control broadcast

This command enables broadcast storm recovery mode. If the mode is enabled, broadcast storm
recovery with high and low thresholds is implemented.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in "Broadcast Storm Recovery
Thresholds" table) of the link speed, the switch discards the broadcasts traffic until the broadcast
traffic returns to the low threshold percentage or less. The full implementation is depicted in the
"Broadcast Storm Recovery Thresholds" table.
Table 8-1. Broadcast Storm Recovery Thresholds
Link Speed
10M
100M
1000M
Format
Mode
Global Covnfig

no storm-control broadcast

This command disables broadcast storm recovery mode.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in "Broadcast Storm Recovery
Thresholds" table) of the link speed, the switch discards the broadcasts traffic until the broadcast
traffic returns to the low threshold percentage or less. The full implementation is depicted in the
"Broadcast Storm Recovery Thresholds" table.
Switching Commands
Global Config
100BASE-T half-duplex
100BASE-T full duplex
10BASE-T half duplex
100BASE-T full duplex
High
20
5
5
switchconfig storm-control broadcast
202-10009-01_060204
Low
10
2
2
8-69