No Spanning-Tree Edgeport; Spanning-Tree Forceversion; No Spanning-Tree Forceversion; Spanning-Tree Forward-Time - NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

no spanning-tree edgeport

This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Format
Mode

spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value. The Force Protocol
Version can be one of the following:
• 802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality
supported)
• 802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality
supported)
• 802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
Default
Format
Mode

no spanning-tree forceversion

This command sets the Force Protocol Version parameter to the default value, i.e. 802.1s.
Format
Mode

spanning-tree forward-time

This command sets the Bridge Forward Delay parameter to a new value for the common and
internal spanning tree. The forward-time value is in seconds within a range of 4 to 30, with the
value being greater than or equal to "(Bridge Max Age / 2) + 1".
Default
Format
Mode
Switching Commands
no spanning-tree edgeport
Interface Config
802.1s
spanning-tree forceversion <802.1d | 802.1w | 802.1s>
Global Config
no spanning-tree forceversion
Global Config
15
spanning-tree forward-time <4-30>
Global Config
202-10009-01_060204
8-85