Dot1X Re-Authenticate; Dot1X Re-Authentication; No Dot1X Re-Authentication; Dot1X System-Auth-Control - NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

dot1x re-authenticate

This command begins the re-authentication sequence on the specified port. This command is only
valid if the control mode for the specified port is 'auto'. If the control mode is not 'auto' an error
will be returned.
Format
Mode

dot1x re-authentication

This command enables re-authentication of the supplicant for the specified port.
Default
Format
Mode

no dot1x re-authentication

This command disables re-authentication of the supplicant for the specified port.
Format
Mode

dot1x system-auth-control

This command is used to enable the dot1x authentication support on the switch. By default, the
authentication support is disabled. While disabled, the dot1x configuration is retained and can be
changed, but is not activated.
Default
Format
Mode

no dot1x system-auth-control

This command is used to disable the dot1x authentication support on the switch.
Format
Switching Commands
dot1x re-authenticate <slot/port>
Privileged EXEC
Disabled
dot1x re-authentication
Config
Interface
no dot1x re-authentication
Interface Config
Disabled
dot1x system-auth-control
Global Config
no dot1x system-auth-control
202-10009-01_060204
8-99