Hostroutesaccept; No Hostroutesaccept; Ip Address; No Ip Address - NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

hostroutesaccept

This command enables the RIP hostroutesaccept mode.
Default
Format
Mode

no hostroutesaccept

This command disables the RIP hostroutesaccept mode.
Format
Mode

ip address

This command configures an IP address on an interface.
The value for <ipaddr> is the IP Address of the interface.
The value for <subnetmask> is a 4-digit dotted-decimal number which represents the Subnet Mask
of the interface. This changes the label "IP address" in "show ip interface."
Format
Mode

no ip address

This command deletes an IP address from an interface.
The value for <ipaddr> is the IP Address of the interface.
The value for <subnetmask> is a 4-digit dotted-decimal number which represents the Subnet Mask
of the interface.
Format
Mode
9-20
Enabled
hostroutesaccept
Router RIP Config
no hostroutesaccept
Router RIP Config
ip address <ipaddr> <subnetmask>
Interface Config
no ip address <ipaddr> <subnetmask>
Interface Config
202-10009-01_060204
Routing Commands