Show Radius Statistics - NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Primary Server IP Address Indicates the configured server currently in use for authenti-
Number of configured servers The configured IP address of the authentication server
Max number of retransmits The configured value of the maximum number of times a
Timeout Duration
Accounting Mode
If the optional token 'servers' is included, the following information regarding the configured
RADIUS servers is displayed.
IP Address
Port
Type
Secret Configured

show radius statistics

This command is used to display the statistics for RADIUS or configured server. To show the
confifured RADIUS server statistic, the IP Address specified must match that of a previously
configured RADIUS server. On execution, the following fields are displayed.
Format
Mode
If ip address is not specified than only Invalis Server Address filed is displayed. Otherwise other
listed fields are displayed.
Invalid Server Addresses The number of RADIUS Access-Response packets received
Server IP Address
Round Trip Time
Access Requests
8-110
cation
request packet is retransmitted
The configured timeout value, in seconds, for request re-trans-
missions
Yes or No
IP Address of the configured RADIUS server
The port in use by this server
Primary or secondary
Yes / No
show radius statistics [ipaddr]
Privileged EXEC
from unknown addresses.
The time interval, in hundredths of a second, between the most
recent Access-Reply/Access-Challenge and the Access-Request
that matched it from the RADIUS authentication server.
The number of RADIUS Access-Request packets sent to this
server. This number does not include retransmissions.
202-10009-01_060204
Switching Commands