User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Default
Format
Mode
no spanning-tree configuration name
This command resets the Configuration Identifier Name to its default.
Format
Mode
spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision Level is a
number in the range of 0 to 65535.
Default
Format
Mode
no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value, i.e. 0.
Format
Mode
spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and internal spanning
tree. This will allow this port to transition to Forwarding State without delay.
Format
Mode
8-84
The base MAC address displayed using hexadecimal notation as
specified in IEEE 802 standard.
spanning-tree configuration name <name>
Global Config
no spanning-tree configuration name
Global Config
0
spanning-tree configuration revision <0-65535>
Global Config
no spanning-tree configuration revision
Global Config
spanning-tree edgeport
Interface Config
202-10009-01_060204
Switching Commands