Table of Contents
Advertisement
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Quick Start up User Account Management
Table 6-3.
Quick Start up User Account Management
Command
show users
(in Privileged EXEC)
show loginsession
(in User EXEC)
users passwd <username>
(in Global Config)
copy system:running-config
nvram:startup-config
(in Privileged EXEC)
logout
(in User EXEC and Privileged
EXEC)
Quick Start up IP Address
To view the network parameters the operator can access the device by the following three
methods.
•
Simple Network Management Protocol - SNMP
•
Telnet
Quick Start up
Details
Displays all of the users that are allowed to access the switch
Access Mode - Shows whether the user is able to change
parameters on the switch(Read/Write) or is only able to view
then (Read Only).
As a factory default, admin has Read/Write access and guest
has Read Only access. There can only be one Read/Write user
and up to 5 Read Only users.
Displays all of the login session information
Allows the user to set passwords or change passwords needed
to login
A prompt will appear after the command is entered requesting
the users old password. In the absence of an old password
leave the area blank. The operator must press enter to execute
the command.
The system then prompts the user for a new password then a
prompt to confirm the new password. If the new password and
the confirmed password match a message will be displayed.
User password should not be more than eight characters in
length.
This will save passwords and all other changes to the device.
If you do not save config, all configurations will be lost when a
power cycle is performed on the switch or when the switch is
reset
Logs the user out of the switch
202-10009-01_060204
6-3
Advertisement
Table of Contents
