Show Interface Ethernet - NETGEAR 7300 Series User Manual

Layer 3 managed switch software
Hide thumbs Also See for 7300 Series:
Table of Contents

Advertisement

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Packets Received Without Error The total number of packets (including broadcast pack-
Broadcast Packets Received The total number of packets received that were directed to
Packets Received With Error The number of inbound packets that contained errors pre-
Packets Transmitted Without Error The total number of packets transmitted out of the
Broadcast Packets Transmitted The total number of packets that higher-level protocols
Transmit Packet Errors The number of outbound packets that could not be transmitted
Address Entries Currently In Use The total number of Forwarding Database Address
VLAN Entries Currently In Use The number of VLAN entries presently occupying the
Time Since Counters Last Cleared The elapsed time, in days, hours, minutes, and sec-

show interface ethernet

This command displays detailed statistics for a specific port or for all CPU traffic based upon the
argument.
Format
Mode
The display parameters when the argument is ' <slot/port>' is as follows:
Packets Received
8-4
ets and multicast packets) received by the processor.
the broadcast address. Note that this does not include multicast
packets.
venting them from being deliverable to a higher-layer protocol.
interface.
requested to be transmitted to the Broadcast address, including
those that were discarded or not sent.
because of errors.
Table entries now active on the switch, including learned and
static entries.
VLAN table.
onds since the statistics for this switch were last cleared.
show interface ethernet {<slot/port> | switchport}
Privileged EXEC
Octets Received - The total number of octets of data (including
those in bad packets) received on the network (excluding framing
bits but including FCS octets). This object can be used as a rea-
sonable estimate of ethernet utilization. If greater precision is
desired, the etherStatsPkts and etherStatsOctets objects should be
sampled before and after a common interval. ----- The result of
202-10009-01_060204
Switching Commands

Advertisement

Table of Contents
loading

Table of Contents