Dot1X Timeout - NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Mode

dot1x timeout

This command sets the value, in seconds, of the timer used by the authenticator state machine on
this port. Depending on the token used and the value (in seconds) passed, various timeout
configurable parameters are set. The following tokens are supported.
reauth-period: Sets the value, in seconds, of the timer used by the authenticator state machine on
this port to determine when re-authentication of the supplicant takes place. The reauth-period must
be a value in the range 1 - 65535.
quiet-period: Sets the value, in seconds, of the timer used by the authenticator state machine on
this port to define periods of time in which it will not attempt to acquire a supplicant. The quiet-
period must be a value in the range 0 - 65535.
tx-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this
port to determine when to send an EAPOL EAP Request/Identity frame to the supplicant. The
quiet-period must be a value in the range 1 - 65535.
supp-timeout: Sets the value, in seconds, of the timer used by the authenticator state machine on
this port to timeout the supplicant. The supp-timeout must be a value in the range 1 - 65535.
server-timeout: Sets the value, in seconds, of the timer used by the authenticator state machine on
this port to timeout the authentication server. The supp-timeout must be a value in the range 1 -
65535.
Default
Format
Mode
8-100
Global Config
reauth-period: 3600 seconds
quiet-period: 60 seconds
tx-period: 30 seconds
supp-timeout: 30 seconds
server-timeout: 30 seconds
dot1x timeout {{reauth-period <seconds>} | {quiet-period <sec-
onds>} | {tx-period <seconds>} | {supp-timeout <seconds>} |
{server-timeout <seconds>}}
Interface Config
202-10009-01_060204
Switching Commands