User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
remotecon timeout
This command sets the remote connection session timeout value, in minutes. A session is active as
long as the session has been idle for the value set. A value of 0 indicates that a session remains
active indefinitely. The time is a decimal value from 0 to 160.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default
Format
Mode
no remotecon timeout
This command sets the remote connection session timeout value, in minutes, to the default.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default 5
Format
Mode
serial baudrate
This command specifies the communication rate of the terminal interface. The supported rates are
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default
Format
Mode
no serial baudrate
This command sets the communication rate of the terminal interface to 9600.
Format
Mode
8-22
5
remotecon timeout <0-160>
Privileged EXEC
no remotecon timeout
Privileged EXEC
9600
serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 |
38400 | 57600 | 115200}
Line Config
no serial baudrate
Line Config
202-10009-01_060204
Switching Commands