User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Burned in MAC Address Universally assigned network address.
Software Version
Operating System
Network Processing Element The type of the processor microcode.
Additional Packages
show interface
This command displays a summary of statistics for a specific port or a count of all CPU traffic
based upon the argument.
Format
Mode
The display parameters when the argument is ' <slot/port>' is as follows:
Packets Received Without Error The total number of packets (including broadcast pack-
Packets Received With Error The number of inbound packets that contained errors pre-
Broadcast Packets Received The total number of packets received that were directed to
Packets Transmitted Without Error The total number of packets transmitted out of the
Transmit Packets Errors The number of outbound packets that could not be transmitted
Collisions Frames
Time Since Counters Last Cleared The elapsed time, in days, hours, minutes, and sec-
The display parameters when the argument is 'switchport' is as follows:
Switching Commands
The release.version.revision number of the code currently run-
ning on the switch.
The operating system currently running on the switch.
This displays the additional packages that are incorporated into
this system, such as 7300 Series L3 Switch BGP-4, or 7300
Series L3 Switch Multicast.
show interface {<slot/port> | switchport}
Privileged EXEC
ets and multicast packets) received by the processor.
venting them from being deliverable to a higher-layer protocol.
the broadcast address. Note that this does not include multicast
packets.
interface.
because of errors.
The best estimate of the total number of collisions on this Ether-
net segment.
onds since the statistics for this port were last cleared.
202-10009-01_060204
8-3