User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
no distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Format
Mode
distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Default
Format
Mode
no distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Format
Mode
no default-information originate
This command is used to control the advertisement of default routes.
Format
Mode
encapsulation
This command configures the link layer encapsulation type for the packet. Acceptable values for
<encapstype> are Ethernet and SNAP. The default is Ethernet.
Format
Mode
9-18
no distribute-list <1-199> out {rip | bgp | static |
connected}
Router OSPF Config
0
distribute-list <1-199> out {ospf | bgp | static |
connected}
Router RIP Config
no distribute-list <1-199> out {ospf | bgp | static |
connected}
Router RIP Config
no default-information originate
Router RIP Config
encapsulation {ethernet | snap}
Interface Config
202-10009-01_060204
Routing Commands