Show Trapflags - NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Status

show trapflags

This command displays trap conditions. Configure which traps the switch should generate by
enabling or disabling the trap condition. If a trap condition is enabled and the condition is detected,
the switch's SNMP agent sends the trap to all enabled trap receivers. The switch does not have to
be reset to implement the changes. Cold and warm start traps are always generated and cannot be
disabled.
Format
Mode
Authentication Flag
Link Up/Down Flag
Multiple Users Flag
Spanning Tree Flag
Broadcast Storm Flag
DVMRP Traps
OSPF Traps
PIM Traps
8-28
A pull down menu that indicates the receiver's status(enabled or
disabled) and allows the administrator/user to perform actions on
this user entry:
Enable - send traps to the receiver
Disable - do not send traps to the receiver.
Delete - remove the table entry.
show trapflags
Privileged EXEC
May be enabled or disabled. The factory default is enabled. Indi-
cates whether authentication failure traps will be sent.
May be enabled or disabled. The factory default is enabled. Indi-
cates whether link status traps will be sent. Multiple Users Flag.
May be enabled or disabled. The factory default is enabled. Indi-
cates whether a trap will be sent when the same user ID is logged
into the switch more than once at the same time (either via telnet
or serial port).
May be enabled or disabled. The factory default is enabled. Indi-
cates whether spanning tree traps will be sent.
May be enabled or disabled. The factory default is enabled. Indi-
cates whether broadcast storm traps will be sent.
May be enabled or disabled. The factory default is disabled. Indi-
cates whether DVMRP traps will be sent.
May be enabled or disabled. The factory default is disabled. Indi-
cates whether OSPF traps will be sent.
May be enabled or disabled. The factory default is disabled. Indi-
cates whether PIM traps will be sent.
202-10009-01_060204
Switching Commands