Table of Contents
Advertisement
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Format
Mode
SNMP Community Name The community string to which this entry grants access. A valid
Client IP Address -
Client IP Mask -
Access Mode
Status
show snmptrap
This command displays SNMP trap receivers. Trap messages are sent across a network to an
SNMP Network Manager. These messages alert the manager to events occurring within the switch
or on the network. Six trap receivers are simultaneously supported.
Format
Mode
SNMP Trap Name
IP Address
Switching Commands
show snmpcommunity
Privileged EXEC
entry is a case-sensitive alphanumeric string of up to 16 charac-
ters. Each row of this table must contain a unique community
name.
An IP address (or portion thereof) from which this device will
accept SNMP packets with the associated community. The
requesting entity's IP address is ANDed with the Subnet Mask
before being compared to the IP Address.
Note: That if the Subnet Mask is set to 0.0.0.0, an IP Address of
0.0.0.0 matches all IP addresses. The default value is 0.0.0.0
A mask to be ANDed with the requesting entity's IP address
before comparison with IP Address. If the result matches with IP
Address then the address is an authenticated IP address. For
example, if the IP Address = 9.47.128.0 and the corresponding
Subnet Mask = 255.255.255.0 a range of incoming IP addresses
would match, i.e. the incoming IP Address could equal
9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0
The access level for this community string.
The status of this community access entry.
show snmptrap
Privileged EXEC
The community string of the SNMP trap packet sent to the trap
manager. This may be up to 16 alphanumeric characters. This
string is case sensitive.
The IP address to receive SNMP traps from this device. Enter 4
numbers between 0 and 255 separated by periods.
202-10009-01_060204
8-27
Advertisement
Table of Contents
