Pontiac Fiero 1988 Service Manual page 874

MUNCIE 282 (5-SPEED) MANUAL TRANSAXLE 7B3-13
10. Two bolts 50 N-m (37 lb. ft.) attaching clutch
slave cylinder bracket.
11. Two bolts 10 Nnn (89 lb. in.) retaining select
cable mount.
12. Select and shift cable to mount on stud with nut
10 Nnn (89 lb. in.).
13. Select and shift cables nut 25 Nnn (18 lb. ft.).
14. Back-up light switch 34 Nnn (25 lb. ft.) and
wire.
15. Drain plug 24 Nnn (18 lb. ft.).
16. Remove screw and retainer from permanent magnet
generator and fill transaxle with Syncromesh Trans-
mission Fluid (12345349) or equivalent. Install re-
tainer and screw 5 Nnn (45 lb. in.).
REAR T R A N S A X L E MOUNT
Remove or Disconnect
1. Disconnect negative battery cable.
2. Remove two nuts and wire harness from studs
attaching lower half of transaxle mount to
frame.
3. Install J 28467-A, J 35563, engine support fix-
ture. Attach fixture hook to engine lift ring and
raise engine enough to take the pressure off the
mount (Figure 7).
4. Four bolts attaching rear transaxle mount to
transaxle.
5. Nut from stud connecting upper and lower halves
of mount.
Install or Connect
1. Nut 48 Nnn (35 lb. ft.) connecting upper and
lower mount halves.
2. Four bolts attaching rear transaxle mount 55
Nnn (41 lb. ft.).
3. Lower engine and remove tools J 28467-A, and
J 35563.
4. Two nuts and wire harness 48 Nnn (35 lb. ft.)
attaching rear transaxle mount to frame.
5. Negative battery cable.
FRONT T R A N S A X L E MOUNT
Remove or Disconnect
1. Negative battery cable.
2. Two bolts attaching upper half of transaxle
mount.
3. Nut from stud attaching coolant pipe to stud and
stud from mount.