Pontiac Fiero 1988 Service Manual page 1340

REAR
QUARTERS 6J-7
19
HEX
NUT
(1)
20 PANEL
21 RETAINER CLIP (2)
22 SEAL STRIP
G94127
Fig. 10-Applique Panel Assembly
23 VALVE SCREW (1)
24 UPPER VALVE
G94128
Fig. 11-Upper Pressure Relief Valve
FUEL TANK FILLER DOOR
LOCKING FUEL FILLER DOOR AND POCKET
ASSEMBLY
I4-4I Remove or Disconnect (Figure 12)
1 _ Two filler door hinge screws
2. Filler door (25)
3. Two pocket screws
4. Latch screw (26)
5. Latch (27)
6. Cable (28) from latch (27)
7. Ppcket (29)
[ H H H | Install or Connect (Figure 12)
1. Cable (28) through pocket (29)
2. Pocket (29) and pocket screws
3. Cable (28) to latch (27)
4. Latch (27) and latch screw (26)
5. Filler door (25) and hinge screws
FUEL FILLER DOOR REMOTE LATCH AND
CABLE ASSEMBLY
J 4 - 4 J
Remove or Disconnect (Figures
12
and 13)
Fuel filler door (25)
Latch (27) and cable (28) from latch
Upper shoulder belt anchor assembly
Rear quarter trim panel
Latch release screw and handle (30)
Applique panel assembly
Screw and bracket (31)
Cable (28) from handle (30)
j-M-| Install or Connect (Figures 12 and 13)
2.
3.
4.
5.
6.
7.
Cable (28) in body
Bracket (31) and screw
Cable (28) to handle (30)
Applique panel assembly
Latch release handle (30) and screw
Rear quarter trim panel
Upper shoulder belt anchor assembly
Q
Tighten
Anchor bolt from 35 to 48 N-m (26 to 35 ft-lb)
8. Cable (28) and latch (27)
9. Latch (27) and fuel filler door (25)
EXTERIOR PANELS AND MOLDINGS
REAR WHEELHOUSE PANEL
4-4
Remove or Disconnect (Figure 14)
1. Six push-pull retainers (32)
2. Eight attaching screws (33)
3. Panel (34)
44- Install or Connect (Figure 14)
1. Panel (34)
2. Eight attaching screws (33)
3. Six push-pull retainers (32)
NOTICE: To prevent damage to plastic or
fiberglass panels, hand start screws to ensure
correct alignment.
REAR FENDER FINISH MOLDING
|4°4J Remove or Disconnect (Figure 15)
1. Two push-pull retainers (35)