Pontiac Fiero 1988 Service Manual page 1349

7 J 4 REAR END
3 TORQUE ROD
10 PLYWOOD BOARD
13 SCREW
14 CARBURETOR AIR INTAKE
G94140
Fig. 6-Rear Compartment Lid Torque Rod Detached
15 STRIKER
16 BOLT — STRIKER RETAINING (2)
G94141
Fig. 7-Rear Compartment Lid Striker
REAR C O M P A R T M E N T LOCK CYLINDER
37 Style
Remove or Disconnect (Figure S)
4*^
1. Screw or rivet (22)
2. Retainer (21)
3. Cylinder (19) and gasket (20)
Install or Connect (Figure 9)
2. Retainer (21)
3. Screw or rivet (22)
97 Style
Remove or Disconnect (Fig. 10)
Screws (22A) four required
4 - *
1.
2.
3.
4.
1.
2.
3.
4.
Cover (20A)
Retainer (21 A)
Lock cylinder (19A) from support (23A)
Install or Connect
Lock cylinder (19A) to support (23A)
Retainer (21 A)
Cover (20A)
Screws (22A)
R E M O T E CONTROL DECK LID R E L E A S E
SOLENOID
4-#
1.
2.
3.
1.
2.
3.
Remove or Disconnect (Figure 11)
Screw (24)
Electrical connector
Solenoid (23). Slide solenoid from latch to
disengage tab.
Install or Connect (Figure 11)
Solenoid (23). Engage tab on latch.
Screw (24)
Electrical connector
REAR C O M P A R T M E N T A J A R S W I T C H
The rear compartment ajar switch is located at
the top left corner of the stowage compartment. This
switch indicates if the rear compartment lid is not fully
closed by sending electrical current to an indicator
light located in the instrument panel.
4-HM Remove or Disconnect
1. Pull up on switch to disengage switch from body
2. Electrical connector from switch
-•4-
Install or Connect
1. Electrical connector to switch
2. Switch to body
REAR C O M P A R T M E N T LID A D J U S T M E N T
The following adjustment procedures identify
rear compartment lid misalignment conditions. More
than one condition may be present. Perform
adjustments only as required for correct alignment and
operation.
ft Adjust (Figures 1 and 7)
1. Cylinder (19) and gasket (20)
Trailing edge too high or low
• Loosen bolts (16)