Pontiac Fiero 1988 Service Manual page 817

125C-30
AUTOMATIC TRANSAXLE
610 HOUSING, DIRECT CLUTCH
624 HOUSING, FORWARD CLUTCH
636 WASHER, THRUST (STEPPED SIDE OUT)
35.8MM
(1-13/32")
610
H125-103*A
Figure 72 Assembled Height of Clutch Assemblies
g Install or Connect (Figures 73 and 74)
• Forward and direct clutch assemblies into case
IH
Measure (Figure 74)
• Case face to housing - 42 mm (1-11/16")
A INPUT SHAFT
610 CLUTCH, DIRECT
624 CLUTCH, FORWARD
624
Figure 73 Installing the Clutch Assemblies
610 HOUSING & DRUM ASM., DIRECT CLUTCH
Figure 74 Proper Clutch Installation
INTERMEDIATE BAND ASSEMBLY
J9
Inspect
© Band (606) for burns, flaking or damage
606 BAND ASSEMBLY, INTERMEDIATE
607 PLUG, BAND ANCHOR HOLE
H125C-52-1
Figure 75 Intermediate Band Anchor Hole Plug
Install or Connect (Figure 75)
1. Band (606) - must engage the case lug
2. Plug (607)
DRIVEN SPROCKET SUPPORT
m
m
Inspect (Figure 76 and 26)
Support (602) for cracks, burrs or damage -
passage surface must be flat and smooth
Bushing (603) for damage
Thrust washer (605) for damage
Oil seal rings (604) for nicks, cuts or damage
oil
-J-2619-01
-J-8092
J-28677
601 BEARING ASSEMBLY V 3 > "
H 125-106<
602 SUPPORT ASSEMBLY, DRIVEN SPROCKET
Figure 76 Bearing Replacement
Bearing Replacement Procedure
Remove or Disconnect (Figure 76)
Tools Required:
J-26941 Transmission Case Bearing
Cup Remover
J-6125-1 Slide Hammer
Bearing assembly (601) - use J-26941 and
J-6125-1
Inspect race for damage
Install or Connect
+ 4 -
New bearing - manufacturing identification
faces up
Linkage