Pontiac Fiero 1988 Service Manual page 873

7B3-12 MUNCIE 282
(5-SPEED)
MANUAL TRANSAXLE
1 —RETAINER
2 - CONTROL ASSEMBLY
3 - KNOB
4 - SHIFT CABLE
5 - SELECT CABLE
6 - RETAINER
H 2 0 0 1 7 - 7 B 3
Figure 7 Shift and Select Cable Attachment At Shifter
12. Raise car, see Section OA.
13. Four clutch inspection plate screws and inspec-
tion plate.
14. Lower frame and tilt, see Section 2A.
15. Remove axle shafts, see Section 4D.
16. Two nuts retaining wire harness on two lower
studs.
17. Two studs and transaxle from bottom of vehicle,
tilt engine down for clearance removal.
F+l Install or Connect
1. Transaxle through bottom and attach engine to
transaxle with two studs. Do not torque studs.
2. Raise frame, see Section 2A, and install axle
shafts, see Section 4D.
3. Clutch inspection plate and four screws 13 Nnn
(10
lb. ft).
4. Front and rear transaxle mounts.
5. Lower car.
6. Lower engine and remove J 28467-A and J
35563.
7. Three upper bolts and one stud 75 Nnn (55 lb.
ft.). Also torque two lower studs in Step 1.
8. Wire harnesses on two lower and center studs
and three nuts 17 Nnn (13 lb. ft.).
9. Exhaust crossover pipe, see Section 6A2.
1 - SELECT CABLE
2 - SHIFT CABLE
3 - 24 N-m (13 FT. LBS.)
4 - SHIFTER ASSEMBLY
5 - RETAINER
H 2 0 0 0 6 - 7 B 3
Figure 8 Transaxle Control Assembly